BitLocker setup could not find a target system drive to prepare
If you lot receive BitLocker Setup could not find a target system drive to gear up, Yous may need to manually prepare your drive for BitLocker message while using the BitLocker Drive Encryption Tool on Windows xi/10 and so this post may be able to assist you lot.
BitLocker Setup could not observe a target system drive to prepare
At that place are two scenarios that can cause this error, says Microsoft.
- Yous do not have sufficient gratuitous disk space
- The sectionalization contains files that cannot be moved.
Y'all do non take sufficient free disk space
For the setup to find that target arrangement drive, at least x pct of the active partition must remain free after the segmentation size is reduced.
To resolve this error, you may run Deejay Cleanup Tool, disable Hibernation to delete the large hiberfil.sys file and movement files to another partition or an external drive.
The partition contains files that cannot exist moved
The BitLocker Drive Grooming Tool may resize partitions to prepare a hard disk for BitLocker. As such, some unmovable files similar the post-obit may forestall the tool from defragmenting and resizing partitions:
- Page files
- Hibernation files (Hiberfil.sys)
- Windows Registry files
- NTFS metadata files similar $mftmirr, $secure, $book, etc.
To resolve this consequence, you need to practise the following:
Disable Paging equally well as temporarily disable hibernation, and delete the Hiberfil.sys file and the Pagefile.sys file. Run the command powercfg -h off in an elevated Command Prompt. It will disable the hibernation style.
To disable the Paging file, nether the Virtual Retentivity settings. Type "performance" in the search bar and open the option for "Adjust appearance and operation for Windows." Under the Advanced tab, click on "Change" in the Virtual Memory section. Uncheck "Automatically manage paging file size for all drives." Select the radio button at "No paging file" and click on Set up. So on OK.
Restart the computer and run the BitLocker Bulldoze Preparation Tool again.
If these steps don't help, you could proceed to the post-obit.
Technet suggests you ensure that TPM is agile and compress the drive, equally follows:
1] Bank check if TPM is agile in BIOS settings
- Restart the computer and the 2nd it turns ON, proceed pressing the F10 key (This key might vary with the brand of the system).
- Navigate to TPM security (It over again varies with the brand of the system).
- Verify that the status is ON and Active.
two] Shrink Drive size
Open Command Prompt (Ambassador) and execute the following command:
C:\Windows\System32\BdeHdCfg.exe -target default -size 300 -repose
Where c: is the System Drive. This volition shrink the drive, create the small BitLocker division and let y'all to run the encryption.
3] Disable the GPO link that configured MBAM
Says Microsoft:
The tool is trying to write the boot files to the new organization drive, only you might have applied an MBAM policy to preclude write-admission to unecnrypted datadrives. With the data drives being unencrypted the organization volume will exist created but the tool will tell y'all that the bulldoze is write protected This is due to the write-access prevention policy you created earlier for MBAM.
To know more than about disabling the Microsoft BitLocker Assistants and Monitoring (MBAM) GPO, please check the reference at docs.microsoft.com.
Once y'all accept run the tool successfully, you lot can relink the MBAM GPO by force-updating the Group Policy by running gpupdate /force.
Related read: BitLocker Setup failed to export the BCD (Boot Configuration Data) store.
Source: https://www.thewindowsclub.com/bitlocker-setup-not-find-target-system-drive-prepare
Posted by: brownandareat.blogspot.com
0 Response to "BitLocker setup could not find a target system drive to prepare"
Post a Comment